DS3810MM GE Gas turbine clamp

Description

Digital port DI5; Set the emergency stop function.

DS3810MM GE Gas turbine clamp

● When running, DI5 must be set to “1”. If it is set to “0”, alarm signal A102 will appear. The drive will react according to the function set in parameter 917 (according to the ramp. Torque/current limiter, regulator lock and

Shutdown in free parking mode. After the ramp function is complete (the response is below nmin), the output is reset by controlling the main loop contactor. After that, the scram input should be reset to “1” The alarm information ON/OFF input is also set to.0. The transmission can then be restarted.

DS3810MM

● Digital port DI7; Set the start 1 stop (ON0OFF) function.

DS3810MM GE Gas turbine clamp

DI7 must be set to logic “1” to connect the drive to the incoming circuit. If there is no fault, it is used to control the armature. The digital output of the contactor closing of the loop and the magnetic field loop is activated. If DI7 is set to “0”, the internal controller stops working and is reset through a delayed digital output. The function set by parameter 915 is effective only if the connection is set according to wiring diagram 2. (Input DI7 and DI8 for breaking contactor)_

Please contact Sunny sales@xiongbagk.cn for the best price.

➱ sales manager: Sunny
➱ email mailto: sales@xiongbagk.cn
➱ Skype/WeChat: 18059884797
➱ phone/Whatsapp: + 86 18059884797
➱ QQ: 3095989363
➱ Website:www.sauldcs.com