Description
Product details:
The 8-point isolated analog voltage source output module (IC670ALG310) accommodates 8 voltage outputs in two isolated groups of 4 each. It provides 8 analog channel voltage outputs with user configurable scaling for each channel. Supports 8 output voltages ranging from -10V to +10V, with a 14-bit resolution.
Output overrange is provided up to approximately 10.25V. Use both word and bit data types. Can be field recalibrated or reset to factory calibration. All calibration data is stored on flash memory.
The individual channel configuration includes output range and scaling parameters. The report scope is less than or exceeds fault. The power supply 8-point isolated analog voltage source output module requires a separate power supply output power.
A single LED indicator shows the module status :ON: The module is running properly. Blinking: The module is faulty. Off: There is no power supply to the backplane, no power supply to the user, or a critical fault occurs.
The 8-point isolated analog voltage source output module uses the following types of data:
0-8 word analog output data
Module and channel status of 0-3 bytes of discrete input data.
The value contains 0 to 2 bytes of discrete output data, which is used to clear alarms.
This module exchanges data with the bus interface unit in the same way as other types of bus interface units The I/O module – when requested by the BIU, it provides all input data and status bits and receives the fault clear command and analog output data from the BIU. The module can also be configured for “group data transmission with BIUs or with other smart devices at the same field control station. Group data describes the interface unit user manual in the bus.
Like other field control modules, 8-point isolated analog voltage source output modules are typically configured from the bus interface unit, using a compatible handheld programmer. The configuration of the module can also be read or written from the system’s bus to support this configuration. The following table summarizes the configuration options and defaults. The module will start with the default configuration Settings. Refer to the Bus Interface Unit User Manual for configuration instructions.
SDCS-UCM-1 | ABB | Extension plate |
SPASO11 | ABB | AO Module |
SPBRC410 | ABB | controller |
SPFCS01 | ABB | Frequency Counter Module |
SPFEC12 | ABB | AI module |
SPNIS21(NIS21) | ABB | Network interface module |
UFC092A V1 HIEE300686R1 | ABB | Channel digital output module |
UNS0007A-P V1 | ABB | Digital I/O card |
UNS0119A-P,V101 3BHE029153R0101 | ABB | Communication control panel |
UNS0122A-P | ABB | Processor end module |
Please contact Sunny sales@xiongbagk.cn for the best price.
➱ sales manager: Sunny
➱ email mailto: sales@xiongbagk.cn
➱ Skype/WeChat: 18059884797
➱ phone/Whatsapp: + 86 18059884797
➱ QQ: 3095989363
➱ Website:www.sauldcs.com