1TGE120010R1300 MNS motor and feeder control unit

Product details:

Extended Product type :MControl Product ID:1TGE121011R1000 Catalog Description :MNS Motors and Feeder Control Units Length Description :MControl (ATEX) Category Products Low-voltage Products and systems Low-voltage Systems IEC-Low-voltage Motor Control Center MNS iS Size Product Net width :53 mm product net height :125 mm product net depth/length :260 mm product net weight: 0.7kg minimum order quantity :1 piece of origin: Czech Republic (CZ) Certificate and declaration (document No.) Declaration of conformity -CE:1t

Extended Product Type:MControl Product ID:1TGE121011R1000 Catalog Description:Motor & Feeder Control Unit for MNS iS Long Description:MControl (ATEX) Categories Products » Low Voltage Products and Systems » Low Voltage Systems » IEC -. Long Description: McOntrol (atex) Categories products » Low voltage products and systems » Low voltage Systems » IEC – Low Voltage Motor Control Centers » MNS iS Dimensions Product Net Width:53 mm Product Net Height:125 mm Product Net. Low voltage motor control centers » MNS is dimensions product net width :53 mm product net height :125 mm product net Depth/Length:260 mm Product Net Weight:0.7 kg Ordering Minimum Order Quantity:1 piece Country of Origin:Czech Republic. Depth/Length:260 mm product net weight :0.7 kg Ordering minimum order quantity :1 piece country of origin :Czech Republic (CZ) Certificates and Declarations (Document Number) Declaration of Conformity – CE:1TGE097001 Instructions and Manuals:1TGC910283M0202 Popular Downloads Data Sheet, Technical Information:1TGC910001B0204 1TGC910809M0202 Instructions and Manuals:1TGC910283M0202 Classifications WEEE Category:Product Not in WEEE Scope

First, the correct connection method of PROFIBUS-DP line is popularized

The correct connection is as follows, without explanation, just look at the picture. PROFIBUS cable is very simple, just two wires inside, a red one and a green one, and then there is a shield on the outside. When wiring, the shielding layer should be connected, and can not be in contact with the wire inside. To separate the line into and out are which, if it is a string, is a bus down, in the middle of continuous access to the sub-station, this is a very commonly used method. The two connectors at both ends of the bus should be connected to the in hole, not the out hole. Then the switch of the two connectors at both ends should be set to the ON state. At this time, only the in connection is connected, while the out connection is broken. The rest of the middle of the joint, are set to OFF, their access to the two wiring is through (memory method: ON means the access terminal resistance, so both ends of the joint dial to ON; OFF means to disconnect the terminal resistance, so the middle connector should be turned OFF).