8BVE0500HC00.000-1  ACOPOSmulti expansion module

Fuse protection must be provided for the cable outlets for the DC bus and 24 VDC connection from the 8BVE
expansion modules. Fuse holders for fuses are thus installed in the 8BVE expansion modules accordingly. The
fuses necessary for operation must be dimensioned based on the application and installed by the user in the 8BVE
expansion modules before commissioning. Suitable fuses are available as 8BXS fuse sets.

8BVE0500HC00.000-1  

When mounting ACOPOSmulti modules for cold-plate or feed-through mounting, be sure not to scratch
the backplane. This can impair thermal dissipation to the mounting plate.
Do not set down ACOPOSmulti modules for cold-plate or feed-through mounting on their bottom side.
Doing so could break the clips that hold the unit is fan. Broken clips make it more difficult to replace
the fans later on.

An additional PE connection must be made between two 8BVE expansion modules in order to meet the conditions
necessary for the ACOPOSmulti drive systems mains connection on all 8B0M mounting plates that are connected
using 8BVE expansion modules. This additional PE connection must be made with the same wire cross section as
the PE wire used for the DC connection (at least 2.5 mm² with protected wiring or 4 mm² with unprotected wiring).