MMS3120/022-000 Dual channel bearing vibration monitor

German EPRO module MMS3120/022-000 Spot sales:
The configuration of the MMS3120/022-000 monitor is done with a portable or desktop PC, the

MMS3120/022-000 is connected to the socket on the front MMS3120/022-000 side of the monitor via an

RS232 interface circuit. The software and measurement results and status monitoring required for the MMS3120/022-000

configuration and the MMS3120/022-000 connection cable between the computer

and the monitor are part of the MMS6910 Configuration kit. In addition, the tool MMS3120/022-000 package comes with a

system manual containing the required instructions for testing and monitoring MMS3120/022-000 measurements and status monitoring.

MMS3120/022-000German EPRO module MMS3120/022-000 Spot sales:
MMS3120/022-000 dual channel bearing vibration monitor is a module of MMS6000 mechanical monitoring

system. The board is MMS3120/022-000 microprocessor control module is designed for measuring and monitoring

all kinds of steam turbine, MMS3120/022-000 compressor, fan and gear box and other machinery bearing vibration. The MMS3120/022-000

can also use piezoelectric sensors instead of seismic sensors.

Importantly, the corresponding amplifying MMS3120/022-000 synthesizes a sensor signal proportional to the vibration frequency.

Thus, the signal will be converted to a signal proportional to the vibration frequency of MMS3120/022-000. The two channels

of the MMS3120/022-000 monitor are independent of each other. Each channel of the MMS3120/022-000 can be configured

separately (such as measuring range, sensor type and limit value, etc.). Each channel calculates its own eigenvalue and MMS3120/022-000 and monitors its overrun and system sensor failures.
German EPRO module MMS3120/022-000 Spot sales:
MMS3120/022-000 In the dual channel independent measurement mode, MMS3120/022-000 each channel can be

separately set two groups of alarm value and danger value. The mode used for the dual channel joint MMS3120/022-000

is described later. In order to avoid the change of MMS3120/022-000 measurement value near the limit repeatedly

trigger the alarm, MMS3120/022-000 can set the alarm lag value, MMS3120/022-000 in the full range of 1-20% choice.

b. Limit multiplier and MMS3120/022-000 multiplier X In special circumstances such as over critical

speed, in order to avoid unnecessary MMS3120/022-000 alarm or jump, you can activate the function of MMS3120/022-000

limit multiplier in the software, and set the multiplier X (1.00~5.00). When using MMS3120/022-000, d18 should be low. The

multiplication factor X affects both the alarm value and the danger value. c. Alarm output