DS200TCQCG1AJD BOARD- (R-S-T) OVERFLOW

The GE RST Overflow Board DS200TCQCG1AHD is populated with 24 jumpers and 3 40-pin connectors.

It also has 3 34-pin connectors and 1 16-pin connector. The ID assigned to the 16-pin connector is JC. The

IDs assigned to the 40-pin connectors are JFF, JE, and 6PL. The 24 jumpers on the GE RST Overflow Board

DS200TCQCG1AHD play an important role in the configuration of the board. The jumpers have two positions on

which the installer can set the jumpers. Depending on the selection, the board will process information differently. The

jumpers are defined as 3 pin jumpers. That is, the jumper can cover pins 1 and 2 or pins 2 and 3. The jumper makes

an electrical contact between the two pins it covers. Some of the jumpers are not set by the installer but are used by the

factory during product testing. In that case, one position is for use by the manufacturer and the other is for use during normal operations.

The jumpers are set before the board is installed in the drive and require the information supplied by the

installation manual to understand the available configuration options. Normally the engineers and management

of the installation site confer with the installer. From that communication, the installer knows how the engineers want to set the jumpers.

To set the jumpers, arrange the board on a clean, dry, and sturdy work space and place a static protective

material under the board. This might be the static protective bag the board was shipped in.