DMC2 50720P Digital Motion Control Sysytem Part A

A label (see Figure 1 for location) and Figure 2 for containing pertinent product identification information is affixed to the DMC2 unit. The product label fields

relevant to product identification are described below Table 1.

TRADEMARK ACKNOWLEDGEMENTS

IBM, IBM PC, AT and PC/XT are registered trademarks of International Business Machines Corporation.

Intel is a registered trademark of Intel Corporation, registered in the United States Patent and Trademark Office.

Microsoft, MS-DOS, Excel and Windows are registered trademarks of Microsoft Corporation, registered in the United States and Trademark Office.

Novell and NetWare are registered trademarks of Novell Inc., registered in the United States Patent and Trademark Office.

PROPRIETARY STATEMENT

The digitally encoded software included in the DMC2 is copyrighted 2001 by Inmotion Technologies AB. All rights reserved. This software may not be

reproduced, modified, displayed, transferred or copied in any form or in any media, in whole or in part, without the express written from us.

WARRANTY STATEMENT

We make no warranty of any kind including, but not limited to, any implied warranties of merchantability and fitness for a particular purpose with regard to this

manual. We assumes no responsibility or liability for errors contained in this manual or for incidental, special or consequential damages arising out of the

furnishing of this manual, or the use of this manual in operating the equipment, or in connection with the performance of the equipment when operated.

DMC2 50720P

CERTIFICATION

• The DMC2 shall be put into operation and be used only by authorized personnel.

• Local or national safety regulations in the field of electrical installation shall be followed.

ELECTRICAL REGULATIONS

• The system is driven by high voltage level of 3-phase 400 VAC. Make sure that the system is not connected to mains when installation, service or repair is

done.

• The system must be turned off before changing cables or accessories.
• Non-Compliance with the installation instructions in this manual can either damage the system or cause an electrical shock.

• The system can start automatically when mains are turned on depending on how the hardware and software configuration is defined.

• When a computer is connected to the DMC2 unit, make sure that both the DMC2 and the computer are connected to earth ground, for avoidance of

unpredictable voltage swing.

MECHANICAL REGULATIONS

• The servo motor connected to the DMC2 unit consists of moving parts and can perform high torque’s and/or speed in short time (within a few ms).

• Some parts of the DMC2 unit can be very warm, up to 90°C.
• The system shall be installed in a cabinet that gives Pollution Degree 2