1732D-8CFGM8 1732 ArmorBlock I/O

The DeviceNet 1732D ArmorBlock™ I/O family consists of stand-alone 24V dc I/O modules that communicate via the
DeviceNet network. The sealed IP67 housing of these modules requires no enclosure (Note that environmental requirements other
than IP67 may require an additional appropriate enclosure.) I/O connectors are sealed M8 (pico) or M12 (micro) styles while the
network and auxiliary power connectors are sealed M12 style.

To install the module:
• Set the node address
• Mount the module
• Connect the cord sets
• Attach the network cables
• Communicate with the module
Set the Node Address Valid node addresses are 00 through 63.
Set the node address using either the rotary switches, RSNetWorx for DeviceNet, DeviceNetManager, or another software configuration
tool. Setting the switches at any number from 64 to 99 lets the software have address control.
Each module is shipped set for node address 63. Remove the caps on
the front of the module to access the switches. The two switches are:
• X10 (most significant digit) – left side of module
• X1 (least significant digit) – right side of module
To reset the node address, use a small blade screwdriver to rotate the
switches. Line up the small black dot on the switch with the number setting you wish to use and then cycle power

1732D-8CFGM8