2098-DSD-HV100-SE   Ultra3000 Digital Servo Drives

The 2098-DSD-HV100-SE is a Ultra 3000 Servo Drive module. This Servo drive module is equipped with

Serial Real-Time Communication Systems (SERCOS) interface, through the dual SERCOS port that utilize

Fiber optic cable connection. This enables this drive to directly communication with Programmable Automation

Controllers (PAC) that is installed with SERCOS module. Additionally, this servo motor may be coupled to MP-Series, 1326AB, F-, H-, N-, and Y-Series servo motors.

Aside from the SERCOS interface, this drive meets the standard capability of an Ultra 3000 drive. For

advanced integration, this drive supports the premiere integration option. This integration option allows Servo

drive parameters to be integrated as instruction and become embedded to the user program and included to the

scan cycle of the controller. This method allows drive parameters to be changed dynamically, depending on the

pre-defined conditions and values set to the program. This minimizes the need of operator intervention to modify drive settings.

The 2098-DSD-HV100-SE output characteristics include an output current of 23 A and with continuous output power of 2.5 kW at 230VAC input and 5.0 kW at 460VAC input.

2098-DSD-020XC

There are two SERCOS fiber-optic cables in this module. The 2098-DSD-HV100-SE has an input voltage (AC) of

230-480V AC root means square (three-phase). The input frequency (AC) of this module is 47-63 Hertz. The nominal

input current (AC) of this module is 14A root means square. It also has a 23A (0 to peak) continuous output current and

46 A (0 to peak) intermittent output current. The dimensions of this module are 9.54 x 14.2 x 5.97 in (242.2 x 360.7 x

151.6 mm). The weight of this module is around 10.44 kg (22.96 lbs). The 2098-DSD-HV100-SE is intended for use

in industrial environments. This module is used in an environment with a pollution rating no higher than Pollution 2 (as

defined in EN / IEC0664-1) when applied in a Zone 2 environment. This module has an Autobaud that allows the drive

to determine the network data rate. This module also supports Automatic Device Replacement (ADR). This module

contains a set of parameters used to configure and monitor drives. This module can configure by changing the values

associated with individual parameters. The Bus capacitance of this module is 705 µF. The internal shunt resistance

of this module is 40 ohms. The SERCOS Communication rates of this module are 4 and 8 Mbps. The node addresses

are from 01 to 99. Please verify that no power is applied to the SERCOS fiber-optic drive and that the cables plugged properly into the Tx and Rx connectors.